1 / 6
Expanded back for the Lilygo T-Lora Pager
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modified back to accommodate larger battery size. Compatible with T-Lora Pager models 433/868/915/920MHz.
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 198
- Makes
- 0
- Views
- 936
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution
Modified the back of the T-Lora Pager to allow for a larger battery. The extra unused antenna “wing” was also removed.
*Note* This is a fairly involved teardown and rebuild of the T-Lora Pager and you do so at your own risk.
Refer to the PDF walkthrough document for the breakdown and rebuild procedure.
What you will need:
- T-Lora Pager model 433/868/915/920MHz
- Small Phillips screw driver
- Soldering iron
- Guitar picks or plastic “spudger”
- MakerFocus 3000mAh battery with a Micro JST 1.25 connector
- 3950 NTC 10K thermistor
- Panel mount switch
- 20 gauge wire or similar
- M2 screws for mounting the switch
- Heat shrink tube
- T-Lora Pager back (3D printed in PET-G preferred)
Printing:
I printed this with the back to the bed and used supports under the antenna cutout.
If you would like to support me, you can do so here: https://buymeacoffee.com/cod3doomy