Glassbed Corner Brackets for FlashForge Dreamer for 3mm Plates (flat)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glassbed Corner Brackets for FlashForge Dreamer for 3mm Plates (flat)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 228
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Because the original print plate of the FIashForge Dreamer is an additional thermal resistance between the heat bed an the glass plate I removed it to decrease the temperature difference between measured (and controlled) temperature of the heat bed and the real temperature of the glass plate.
But now the original brackets were a little bit too high sometimes causing a collision between the nozzles and the brackets.
So I reduced the height of the brackets to let them fit again.
Print Settings
Printer:
FIashForge Dreamer
Rafts:
No
Supports:
Yes
Resolution:
0.10 mm
Infill:
75% or higher
Notes:
Use ABS because of the high environment temperature.
A high infill percentage increases the stability against deformation. Try the best infill rate for maximal stability and minimal warping.
Category: 3D Printer Accessories