Glassbed Corner Brackets for FlashForge Dreamer for 3mm Plates (flat)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Glassbed Corner Brackets for FlashForge Dreamer for 3mm Plates (flat)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 18
- Makes
- 0
- Views
- 228
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Because the original print plate of the FIashForge Dreamer is an additional thermal resistance between the heat bed an the glass plate I removed it to decrease the temperature difference between measured (and controlled) temperature of the heat bed and the real temperature of the glass plate.
But now the original brackets were a little bit too high sometimes causing a collision between the nozzles and the brackets.
So I reduced the height of the brackets to let them fit again.
Print Settings
Printer:
FIashForge Dreamer
Rafts:
No
Supports:
Yes
Resolution:
0.10 mm
Infill:
75% or higher
Notes:
Use ABS because of the high environment temperature.
A high infill percentage increases the stability against deformation. Try the best infill rate for maximal stability and minimal warping.
Category: 3D Printer Accessories