1/2" EMT Conduit Connectors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I began designing these to make a custom cover for my generator. I'll be sewing the cover soon to fit over the frame.I…
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 191
- Wydruki
- 1
- Wyświetlenia
- 701
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
I began designing these to make a custom cover for my generator. I'll be sewing the cover soon to fit over the frame.
I made several other types since they are all just different configurations of the same design. These could be used to make all kinds of structures out of cheap 1/2" EMT conduit.
The hole for the conduit is basically friction fit, but not super tight. I added hole that can be used to thread 4mm screws for a tighter fit. This is what I did. If you go that route, be careful not to overtighten the screw. Another option would be to drill holes in the conduit and screw through the fittings into the conduit for a much more secure fit.
The conduit hole on the the "through tee" is slightly larger to accommodate sliding over the conduit. I included a smaller cap and through hole piece that can be used to test your printer settings and tolerance.
I don't know that I would use this for anything very structural, but worked nicely for my purposes. I'd love to hear suggestions for other uses or how they could be improved.
I printed mine using PETG, 0.28mm layers, 4 walls, and 15% cubic infill. No supports should be needed.
EDIT: I had a request for a 5 way connector. I added 1 solid and 1 with a through hole.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 Max
Rafts:
No
Supports:
No
Resolution:
0.28
Infill:
15%
Filament: ELEGOO PETG Black Category: DIY