1 / 3
16g Begleri Bead for 550 Paracord — zdjęcie 1
1 / 3

16g Begleri Bead for 550 Paracord

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3d printable begleri skill toy beads that are large enough for good weight, quick print

Ocena
0 / 5
Polubienia
21
Pobrania
58
Wydruki
0
Wyświetlenia
431
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

PLEASE CHECK OUT THE V2 HERE: Begleri Bead V2 - for 550 Paracord by Eligh Small | Download free STL model | Printables.com

This is a model for a begleri bead that does not require hex nuts, it is a bit on the larger side but when printed at high density (90% +) it gives good weight for the toy. 

Paracord requires a simple overhand knot and then it can be pulled into the cavity so you do not see it.

I recommend printing out of PLA or PETG, ABS and ASA are much lower density and wont give as much weight.
TPU would also work and is a similar density to PLA, this would make them less loud when they bang together

This took me 1 hour to print 2 beads on my Bambu labs p1s at 97% density and a 0.28mm layer height so it is a relatively quick print and came out at around 16g each.

The fit on the hole is a little tight for the paracord I had, but it is easily pushed through with an Allen key or something similar.

PRINT SETTINGS:

0.2 or 0.28mm layer height, detail is minimally affected so dealers choice

90% or higher infill for good weight

no supports or brim should be required

Tagi