PTFE tube guide for SE3D Elegoo Centauri Carbon toolhead cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made a lightweight PTFE tube guide that slides into the SE3D toolhead cover.
- Ocena
- 5 / 5
- Polubienia
- 71
- Pobrania
- 417
- Wydruki
- 1
- Wyświetlenia
- 2686
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
After a few test prints with the new toolhead cover, I noticed that the PTFE tube was rubbing against the glass quite a bit and also tugging and rattling the riser. Loading the filament was also an issue. To counteract this I designed this model. The part is under 2g so it's very lightweight and prints in about 12min.
Print with PETG or ABS/ASA and with supports ON for the countersunk hole.
Installation is simple:
If you already have the toolhead cover installed, just remove the front part of the cover and slide the bottom section of the printed model into place.