PTFE tube guide for SE3D Elegoo Centauri Carbon toolhead cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made a lightweight PTFE tube guide that slides into the SE3D toolhead cover.
- Rating
- 5 / 5
- Likes
- 71
- Downloads
- 419
- Makes
- 1
- Views
- 2,693
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
After a few test prints with the new toolhead cover, I noticed that the PTFE tube was rubbing against the glass quite a bit and also tugging and rattling the riser. Loading the filament was also an issue. To counteract this I designed this model. The part is under 2g so it's very lightweight and prints in about 12min.
Print with PETG or ABS/ASA and with supports ON for the countersunk hole.
Installation is simple:
If you already have the toolhead cover installed, just remove the front part of the cover and slide the bottom section of the printed model into place.