3 Inch Pipe (Charlotte) Cap + 5/8 Garden Hose Barb Adapter for Hydroponic Tube System
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've printed about 10 of these to ensure the amount of tolerances, etc, are a good blend between "exact" and "your…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 533
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
I've printed about 10 of these to ensure the amount of tolerances, etc, are a good blend between "exact" and "your printers tolerances".
Tube systems for hydroponics are nice and all, but I noticed that the cost of all the fittings for the ends were expensive, AND I was having to invasively cut or drill them out for helping the water reach the next level up, down, or parallel.
INSTRUCTIONS:
- Stick this on to the end of your pipe.
- Use metal clamp to keep water-tight.
- Insert garden hose into inset barbed zone. (No supports required).
- Send hose to another barbed cap like this one.
The barbed section is not in the center, and you can rotate it a bit to have your tube system be "more empty" or "for full", depending on how your set is.
I may create a v2 with a re-enforced base on the inside of the cap (for the barbed column) but I haven't noticed it be necessary yet.
Printing this final version right now, so I'll pictures up soon.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.28 (+ Dynamic .08 max /.04 steps)
Infill:
20% Cubic (This could be 0 most likely)
Filament: Tronxy TPU Blue
Category: DIY