1 / 1
3 Inch Pipe (Charlotte) Cap + 5/8 Garden Hose Barb Adapter for Hydroponic Tube System — image 1

3 Inch Pipe (Charlotte) Cap + 5/8 Garden Hose Barb Adapter for Hydroponic Tube System

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I've printed about 10 of these to ensure the amount of tolerances, etc, are a good blend between "exact" and "your…

Rating
0 / 5
Likes
2
Downloads
36
Makes
0
Views
531
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial

I've printed about 10 of these to ensure the amount of tolerances, etc, are a good blend between "exact" and "your printers tolerances".

Tube systems for hydroponics are nice and all, but I noticed that the cost of all the fittings for the ends were expensive, AND I was having to invasively cut or drill them out for helping the water reach the next level up, down, or parallel.

INSTRUCTIONS:

  • Stick this on to the end of your pipe.
  • Use metal clamp to keep water-tight.
  • Insert garden hose into inset barbed zone. (No supports required).
  • Send hose to another barbed cap like this one.

The barbed section is not in the center, and you can rotate it a bit to have your tube system be "more empty" or "for full", depending on how your set is.

I may create a v2 with a re-enforced base on the inside of the cap (for the barbed column) but I haven't noticed it be necessary yet.

Printing this final version right now, so I'll pictures up soon.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

.28 (+ Dynamic .08 max /.04 steps)

Infill:

20% Cubic (This could be 0 most likely)

Filament: Tronxy TPU Blue

Category: DIY

Tags