Stealth Skirts LED Logo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A LED holder for the stealth skirts model. The size of the logo is just about perfect for a round 7 neopixel display.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Replaces the LED logo inlay for the side fan skirts.
The model is just begging for some LED bling. The round 7 neopixel LED display fits with near perfect alignment to the VORON logo. Small tabs to hold in the display.
The ones that I used: https://www.amazon.com/dp/B0B2D6JDVJ
I'm sure these are common on Aliexpress as well.
Recommended that clear PETG or ABS is used. Print it thin, 2 top and bottom layers, 2 walls, concentric infill with ~10%. The Neopixel should snap in. If needed a little bit of silicon glue to retain it. Then a bit of CA (instant) or plastic cement to hold the clear diffusor to the side skirts.
If printed either logo down or logo up, support will be needed.
Control it per: https://github.com/julianschill/klipper-led_effect/blob/master/README.md