Original ZSA Navigator holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a ZSA Navigator holder, for the voyager; now you can switch your trackball between left and right side.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 451
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
What is this
This is a ZSA Navigator holder, for the voyager keyboard, it allows you to switch your trackball between left and right side.
I have also included a (right side) shim if you use your voyager flat on your desk, it will equalise both sides, but you will need to source your own magnet for it, you should mirror it if you need a shim for the left side.
How to use
Holder
- Print whichever side you would like to try out
- Take out the upper magnet and the original screws from your holder.
- Press the upper magnet in the hollow, it's a press fit.
- Screw the upper magnet (with the countersunk screw holes) in the 3D printed model.
- Press fit your navigator core inside it and use as specified by ZSA.
⚠ Store away the lower bar, (perhaps in the original transportation bag?), you will need it to put back the original holder together..
Shim
- Source a similar upper magnet as the original.
- Print the shim for the side you need (don't forget to mirror it if needed)
- Stick it under your keyboard.
Important to note
The tolerances are pretty tight and is a press to fit, tested in PLA without issue.