1 / 1
Jig and Brace 3 Inch Screw in Everbilt Shelf Bracket (212.34mm hole spacing) for 3/4" — zdjęcie 1

Jig and Brace 3 Inch Screw in Everbilt Shelf Bracket (212.34mm hole spacing) for 3/4"

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Drill new hole in metal bracket. Designed for 3/4" shelf (3/16" leeway to avoid poke through).

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
98
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bedroom
Licencja
Creative Commons — Attribution — Share Alike

The front shank hole matches the existing hole in the Everbilt “20in Shelf Support Bracket” that hooks into the double-slotted vertical rails (actually comes out 18.5" from the bracket when seated). The shank holes are designed for a #10 rear screw and a #8 front screw. It braces the #10 screw, and by that I mean it keeps the end near the wood from wiggling (and therefore the shelf from sliding back and forth) like the built-in metal shaft further back does. They would have to be made bigger if you are using bolts. Further delving into the idea of using wood instead of the full-metal system, the new rear hole that you must drill using this as a guide with a 5/32" bit is back the correct amount so the depth is good for a 3" wood screw.