1 / 1
Jig and Brace 3 Inch Screw in Everbilt Shelf Bracket (212.34mm hole spacing) for 3/4" — image 1

Jig and Brace 3 Inch Screw in Everbilt Shelf Bracket (212.34mm hole spacing) for 3/4"

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Drill new hole in metal bracket. Designed for 3/4" shelf (3/16" leeway to avoid poke through).

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
97
Reviews
0

Updated at source:

Model information

Category
Bedroom
License
Creative Commons — Attribution — Share Alike

The front shank hole matches the existing hole in the Everbilt “20in Shelf Support Bracket” that hooks into the double-slotted vertical rails (actually comes out 18.5" from the bracket when seated). The shank holes are designed for a #10 rear screw and a #8 front screw. It braces the #10 screw, and by that I mean it keeps the end near the wood from wiggling (and therefore the shelf from sliding back and forth) like the built-in metal shaft further back does. They would have to be made bigger if you are using bolts. Further delving into the idea of using wood instead of the full-metal system, the new rear hole that you must drill using this as a guide with a 5/32" bit is back the correct amount so the depth is good for a 3" wood screw.