Water Bottle Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A handle to convert bottles with caps that only have a small, single finger hole to have a full handle that fits a hand
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
My finger would always get tired holding this bottle. clipping it with a carabiner worked, but then it was swaying back and forth, hitting by back or legs depending on where it was clipped. So I wanted to make a full handle so I could just carry it without wearing the cap like a ring. I don't have a model number of bottle that this would fit, but it looks like most of this style have the same one. Try it and let me know.
Printed in PLA with a 0.6 nozzle and 0.25 layer height using the structural setting. Seems to work well. Some of the tolerances were a little too tight, so I adjusted a bit and added cloth tape to make the handle more comfortable.
I made two models. The one pictured is two almost identical halves, held together by two M3 screws and nuts. The second model prints faster and consists of one handle, and one fastening side.
Both models were made in Fusion, and all parts made together. So please be sure to adjust the print so that the flat side is down. I printed with and without supports, and both worked fine with my MK4s, so if you trust your bridging it should be ok, but always safer with supports.