Lid for Raspberry Pi 5 case with NVME M.2 HAT+ : with stoppers to protect SSD

This model is only a replacement lid, with access to the GPIO. The original case body and details is at https://www.printables.com/model/1231715-pi-5-case-with-official-raspberry-m2-hat 

The original case and lid worked perfectly for me. But when I was mounting the Pi and case on the wall I managed to push the lid down onto the HAT. That crashed the Pi. To stop me doing that again I added the small corner blocks to the original lid. Now the lid always remains clear of the HAT and the Pi runs perfectly.

The blocks do not extend beyond the outside of the lid. 

I used OpenSCAD to make the alteration. If you want to use the code you'll need to put the original file “pi5 case hatplus official lid.stl” in the same folder as the code. My parameters are all named so editing the code should be straightforward.

Printing:
In PrusaSlicer I selected “support on build plate only”. Even with the ‘Organic’ setting it took a while to remove all the support material to let the lid engage properly. But it was worth the effort - I'd hate to damage the HAT or the SSD by accidentally pushing the lid down too far.