1 / 1
Simple Qorvo DWM1001-DEV Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A minimal, protective half-case for the Qorvo DWM1001-DEV development boards, with heat set inserts and screws.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A little case for the Qorvo DWM1001-DEV Development Board. Check the list below for compatible boards.
The board should sit quite firmly in the case itself and is held down by additional screws.
Recommended Material & Print Settings
- Nearly every Material should work, Test prints were done in PLA.
- No supports needed.
- Two (or more) perimeters recommended for the screw pegs to be solid enough
Additional Hardware
- 3x M3x10 DIN 912 Cylinder Screws (between 8 and 10mm should be fine)
- 3x M3 Heat Set Inserts (CNC Kitchen ones tested, others may work as well)
Compatible Boards
- Qorvo DWM1001-DEV
- Possibly others?
Please consider liking the model and posting a Make :)
