1 / 1
Simple Qorvo DWM1001-DEV Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A minimal, protective half-case for the Qorvo DWM1001-DEV development boards, with heat set inserts and screws.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 131
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A little case for the Qorvo DWM1001-DEV Development Board. Check the list below for compatible boards.
The board should sit quite firmly in the case itself and is held down by additional screws.
Recommended Material & Print Settings
- Nearly every Material should work, Test prints were done in PLA.
- No supports needed.
- Two (or more) perimeters recommended for the screw pegs to be solid enough
Additional Hardware
- 3x M3x10 DIN 912 Cylinder Screws (between 8 and 10mm should be fine)
- 3x M3 Heat Set Inserts (CNC Kitchen ones tested, others may work as well)
Compatible Boards
- Qorvo DWM1001-DEV
- Possibly others?
Please consider liking the model and posting a Make :)
