Elk Log Periodic Antenna Handle (Remix)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a compact handle that replaces the PVC-based handle setup for the Elk Antennas 2m/70cm log periodic antenna.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 319
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of the model found here: https://www.printables.com/model/250689-elk-log-periodic-antenna-handle
The only change is adding fillets to high stress areas (right angles) to increase strength. I especially noticed fatigue where the handle meets the antenna shaft after just a couple uses and wanted to increase the longevity of the part. The original design is great otherwise: prints well without supports, fits well, easy installation.
See original model description for installation instructions.
I used this foam handle since the one in the original model description was not available (a little shorter but still works well, see picture): https://www.amazon.com/dp/B09MT4L52W
Slicer settings for further increased strength:
- 30% gyroid infill
- 5 walls, 5 top layers, 5 bottom layers
I used ASA filament for increased mechanical strength and UV resistance, but other filaments should work fine too.