Kids Ride Shotgun Spacer for Canyon ebikes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer kit to install Kids Ride Shotgun Pro saddle on Canyon eMTB with internal cable routing.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 67
- Wydruki
- 0
- Wyświetlenia
- 378
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Update 2025-09-15: Added a shield to the top spacer to prevent the wire going into the handlebar through the stem from getting tangled on the screw. Uploaded as a new step file v2.
Designed a custom spacer kit to install onto a Canyon Spectral:ON to use the Kids Ride Shotgun Pro Saddle without purchasing the add-on spacer.
Upper and lower clamp to properly space the clamp ring from the stem and headset. Pins on bottom of lower spacer and top of upper spacer to ensure the spacers are aligned with the steer tube at all times.
Requires 22mm or more steer tube length from the top of the headset cover.
Recommend to print in ASA, PETG, or ABS for strength and UV resistance, 100% infill is recommended. I used .08mm layer lines to ensure the smoothest finish possible on the part that may rub on the cables.
Installation Instructions:
1. Loosen stem screws and remove top cap.
2. Disconnect any short wires between the frame and display to keep them from getting damaged when removing the stem.
3. Remove stem and all spacers.
4. Install the lower spacer, Kids Ride Shotgun spacer, and top spacer onto the steer tube. Note the orientation of the spacers.
5. Replace the stem and top cap.
6. Snug the top cap and stem screws.
7. Align the stem with the front wheel and properly torque the top cap and stem screws.
Note: Install this product at your own risk. Use the manufacturer recommended torque specs for all fasteners. I am not responsible for damage or injury.