Spaced out Anderson Power Poles shell and panel mount.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you need a fourth configuration for your power poles.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Anderson Power Poles gives you three configurations, Both in the same direction, the pos on it's side, or the neg on it's side. Here's a fourth configuration if three is not enough.
This is a shell and a panel mount that spaces the two power poles connectors 2mm apart. These are high precision models, your printer needs to be accurate within 0.1mm for a good fit. Print half of a shell and test fit. If it doesn't fit snug, scale the model 1 or 2 percent in your slicer until you find the scale value that gives a good fit. There is also a template for cutting a hole to use the panel mount version. It relies on a snug fit into the rectangle you cut in the panel.
The panel mount pieces should be printed standing up off their face.