Spaced out Anderson Power Poles shell and panel mount.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
If you need a fourth configuration for your power poles.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 148
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Anderson Power Poles gives you three configurations, Both in the same direction, the pos on it's side, or the neg on it's side. Here's a fourth configuration if three is not enough.
This is a shell and a panel mount that spaces the two power poles connectors 2mm apart. These are high precision models, your printer needs to be accurate within 0.1mm for a good fit. Print half of a shell and test fit. If it doesn't fit snug, scale the model 1 or 2 percent in your slicer until you find the scale value that gives a good fit. There is also a template for cutting a hole to use the panel mount version. It relies on a snug fit into the rectangle you cut in the panel.
The panel mount pieces should be printed standing up off their face.