1 / 3
25 mm × 200 mm Rod / Stick for Vertical Bike Wall Mount — zdjęcie 1
1 / 3

25 mm × 200 mm Rod / Stick for Vertical Bike Wall Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

25 mm × 200 mm rod as a wooden dowel replacement – fits the Vertical Bike Wall Mount (Remix)

Ocena
4,75 / 5
Polubienia
44
Pobrania
386
Wydruki
2
Wyświetlenia
1296
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Description (EN)

I needed a 25 mm diameter, 200 mm long rod for this Vertical Bike Wall Mount (Remixes page) and didn’t want to source a wooden dowel. This printable stick drops in as a direct replacement. Print it solid enough and you’re good to go.

  • Designed as a simple cylindrical rod (Ø 25 mm, length 200 mm)

  • Saves a trip to the hardware store for a wooden dowel

  • Works best in PETG (tough, slightly flexible); PLA is possible if loads are low

Notes: If the fit is tight/loose on your mount, adjust scale slightly (±1–2 %) or sand the surface. Increase perimeters for strength.

Beschreibung (DE)

Für die Vertical Bike Wall Mount (Remixes) brauchte ich einen Stab Ø 25 mm, Länge 200 mm – anstatt einen Holzstab zu besorgen, habe ich einen druckbaren Ersatz erstellt. Einsetzen, fertig.

  • Zylindrischer Stab (Ø 25 mm, Länge 200 mm) als Drop-in-Ersatz

  • Spart den Holzrundstab aus dem Baumarkt

  • PETG empfohlen (zäh/robust); PLA nur bei geringer Belastung

Hinweis: Falls die Passung zu stramm/locker ist, skaliere geringfügig (±1–2 %) oder schleife leicht nach. Für Stabilität Perimeter erhöhen.

Tagi