25 mm × 200 mm Rod / Stick for Vertical Bike Wall Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
25 mm × 200 mm rod as a wooden dowel replacement – fits the Vertical Bike Wall Mount (Remix)
- Rating
- 4.75 / 5
- Likes
- 44
- Downloads
- 386
- Makes
- 2
- Views
- 1,296
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Description (EN)
I needed a 25 mm diameter, 200 mm long rod for this Vertical Bike Wall Mount (Remixes page) and didn’t want to source a wooden dowel. This printable stick drops in as a direct replacement. Print it solid enough and you’re good to go.
Designed as a simple cylindrical rod (Ø 25 mm, length 200 mm)
Saves a trip to the hardware store for a wooden dowel
Works best in PETG (tough, slightly flexible); PLA is possible if loads are low
Notes: If the fit is tight/loose on your mount, adjust scale slightly (±1–2 %) or sand the surface. Increase perimeters for strength.
Beschreibung (DE)
Für die Vertical Bike Wall Mount (Remixes) brauchte ich einen Stab Ø 25 mm, Länge 200 mm – anstatt einen Holzstab zu besorgen, habe ich einen druckbaren Ersatz erstellt. Einsetzen, fertig.
Zylindrischer Stab (Ø 25 mm, Länge 200 mm) als Drop-in-Ersatz
Spart den Holzrundstab aus dem Baumarkt
PETG empfohlen (zäh/robust); PLA nur bei geringer Belastung
Hinweis: Falls die Passung zu stramm/locker ist, skaliere geringfügig (±1–2 %) oder schleife leicht nach. Für Stabilität Perimeter erhöhen.