Headphone Holder for IKEA MITTZON

This cover is designed to snap-fit onto either (or both if you print two!) of the metal hooks that come with IKEA MITTZON desks, to protect the headphones' padding. The hook has sharp edges that can easily damage the pads (or at least deform them if your headphones are hung up long enough) and might not fit headphones with wider bands. The “legs” have protrusions to hold them to the hook, when installing put one side of the hook in first then give the opposite side a push down to snap it into place!

Printing:

I printed in PLA at 0.2mm layer height with 15% Gyroid infill, which in hindsight was probably overkill… The infill could probably be bumped down to 10% and/or switched to Lightning, but if you do use lightning it may be good to add a wall loop or two to make it sturdier. Optionally you can use Prusa/Orca's paint-on fuzzy skin feature to give some texture to the curved side, I haven't tested without so I'm not sure if/how much it actually prevents slipping but it does look nice!

NOTE:

In your slicer make sure the non-sloped back side is on the plate, you can try to print it upright if you want to but it likely won't look as good or be as strong.

Made in FreeCAD, let me know if I should post the .FCStd file for remixes/customization!