Nema 17hs4023 EASYTHREED K10

I apologize for my English, as I translated my language through a translator. I decided to install Easythreed k10 on Nema stepper motors and at the same time increase the print area a little. These parts are not ideal, but still with their help the printer began to print much more accurately and now circles and arcs print more correctly. There is a lot that could be improved and added, but I no longer want to do this. The Print Area with these parts has been increased to 115 mm along two axes X and Y. You need to buy cheap Nema 17hs4023 stepper motors, and you will also need to buy a GT2 belt, since the old one is short. Save the parameters for the machine to a file - k10_cfg.txt (thanks to Aziz Vicentini for the parameter file) and save it to a flash drive. Then connect it to the machine and turn on the machine for 10 seconds. After recording the parameters to the machine, the file will change to - k10_cfg.cur The parameters "Default Axis-X (Y, Z) Steps Per Unit" may be different for you, since the pulley, etc. may differ from what I have. For example, print a test cube 20 * 20 and measure its dimensions by axes and using the formula (divide the current step by the dimensions of the part that you got, and then multiply it by the expected dimensions of that axis, for example 83/20.5 * 20 = 80.97). You can also change the parameters "Invert the stepper direction" depending on which side you installed the fastener.