Louqe Ghost R1 - GPU Support Bracket

This GPU support bracket is designed to be installed on the open rail of the motherboard tray. This part will require 2 M3 heat insert (up to 8 mm thick). Please print on its side as in the last picture. No support needed. There are 2 versions: standard and enhanced.

Recommendation: print in ABS/ASA or HT-PLA for maintenance-free experience as the bracket will directly touch the hot GPU. My PLA-printed bracket (standard) was warped after about 1 week of usage. My preferred version is the enhanced as it is more robust and able to support heavier GPUs. The standard version is good if you need more space for cable management.

Limitation: this part only supports flipped configuration. I have only tested with SFX PSU at the lowest position. I have included .stp and .f3d files for modification if you want to remix or support SFX-L PSU.

Installation:

1. After printing, press 2 M3 heat inserts into the holes.
   • I recommend place the bracket over an edge.
2. Use Ghost R1 screws (same ones as those used to attach PSU bracket to mobo tray) to loosely install the bracket on the open rail as in picture 3. 
   • This step can be done even in completed builds. You will have to make some space from your wiring and maneuver the part into place.
3. With the case upright, adjust the height of the bracket until GPU is leveled to satisfaction.
4. Tighten the screws.