Modular ESRack Unifi PoE module housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An ESrack module to hold up to three PoE injectors from Ubiqiti/Unifi. Adaptable for different injector models.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 428
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A place for my Unifi PoE injectors using the excellent ESRack system by @EvilProphet. (height: 1 Rack unit)
There already are other Unifi holders for ESRack - but since I have a mix of models (and each of the dozen or so PoE injectors by Unifi have slightly different dimensions…) I thought I'd design a modular holder. Bonus: For test prints to check whether the injector fits you don't have to reprint a huge part, but only the small panels!
I created panels for the two models I own: The POE-24-12W and the POE-15-12W. If you have a different model, you can modify the FreeCAD files or create your own based on the blank panels.
In case you need less than three slots, you can close the unneded ones with a blank front panel.
To install the injectors, first push in the front panels. Put in the injectors and slide the back panels from top (see pictures).
Enjoy, show your makes, and drop me a note if you create a new set of panels so I can link them here!