1 / 3
Toyota Tacoma 4th gen phone wireless charge holder — zdjęcie 1
1 / 3

Toyota Tacoma 4th gen phone wireless charge holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A custom bracket to hold my cell phone and a slim wireless charging pad in the OEM center console cubby

Ocena
0 / 5
Polubienia
4
Pobrania
35
Wydruki
0
Wyświetlenia
582
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I was a bit disappointed when my new 4th generation TRD Off-Road didn't come with the wireless phone charging holder in front of the shifter, until I read the complaints around the OEM charger (slow, heats up phone, etc). I decided it was worth it to 3D print my own bracket to do the job with my phone. I use a Samsung Galaxy S21 Ultra with a slim/minimalist phone cover. The bracket is open at the top so phone height is relatively unimportant, and this bracket holds phones up to 82mm wide. It uses a very slim (only 6.6mm tall) wireless charging pad I picked up on Amazon for about $11 from a company called Tozo. 

https://www.amazon.com/dp/B0FDQBDRXN

Very nice fit in the cubby as well as how it holds the phone and the charging pad. Short of an accident or roll-over I doubt the phone will ever bounce its way out. The cable is routed out diagonally down and to the right and plugs into the Type C charging port in the same cubby.  

Printed in PETG, 4 walls, Adaptive Cubic infill at 15%. Supports enabled, Normal type, Default style. Maxed out Variable Layer Height (Adaptive) on the top edges to give a cleaner look and it only adds a few minutes to the print time.

Tagi