Battery cover for Victure HC300 trail camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for battery cover when the old one is broken because of the integrated camera mounting thread
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
Printing
For the sake of stability it is important to print out the part as shown.
I took PETG with 0.2 mm.
Post-print tasks
After cutting away the support structure a little bit of grinding does make sense.
Thread insert
I think it’s easier to print a hexagon than a round hole for the thread insert - it works just as good and you don’t have to remove supporting material. But you should consider making it a bit rounder to assemble the insert more easily.
Guide pin hole
Since printed hole is not accurate enough it does make sense to drill after printing. You can drill a slightly bigger hole, if you want the cover to not close that tightly.
Mounting of contact plates
Disassemble the contact blades with the 6 screws from the original part and mount it on your cover. Should just work without any drilling.
Guide pin assembly
Guide pin has a thick and a thin side. You can push it out in wrong direction as well (like I did), but its less convenient. A drill press with a 2 mm drill bit clamped in upside down is well suited for pushing out the bolt.
