Battery cover for Victure HC300 trail camera
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for battery cover when the old one is broken because of the integrated camera mounting thread
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 76
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Public Domain
Printing
For the sake of stability it is important to print out the part as shown.

I took PETG with 0.2 mm.
Post-print tasks
After cutting away the support structure a little bit of grinding does make sense.
Thread insert
I think it’s easier to print a hexagon than a round hole for the thread insert - it works just as good and you don’t have to remove supporting material. But you should consider making it a bit rounder to assemble the insert more easily.
Guide pin hole
Since printed hole is not accurate enough it does make sense to drill after printing. You can drill a slightly bigger hole, if you want the cover to not close that tightly.

Mounting of contact plates
Disassemble the contact blades with the 6 screws from the original part and mount it on your cover. Should just work without any drilling.
Guide pin assembly
Guide pin has a thick and a thin side. You can push it out in wrong direction as well (like I did), but its less convenient. A drill press with a 2 mm drill bit clamped in upside down is well suited for pushing out the bolt.
