1 / 2
Baristina Plumb-in Reservoir Lid (Direct Water-Line  Adapter) — zdjęcie 1
1 / 2

Baristina Plumb-in Reservoir Lid (Direct Water-Line Adapter)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Snap-in lid to connect the water reservoir to a supply line.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
89
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

I wanted to connect the water reservoir to a supply line so I wouldn't have to keep taking it in and out. I had already plumbed in a supply line in the wall with a recent kitchen remodel, but if you have a ¼ inch supply line going to your fridge, you could tap into that with a splitter.

The new lid snaps on instead of sitting on top like the original one so that the extra weight on top or the water pressure doesn't pull the lid off.

You'll need to buy some ¼ inch push-fit/quick-connect parts (like these, although there are lots of other options), and plus a ¼ inch push-fit bulkhead (like these). There may be combinations online that include the hose and all the parts together in smaller quantities. If you are tapping into your refrigerator line, some of those are 3/8 inch or have a braided supply line, so you'll need to figure out what parts to get.

I used TPU to print because it's a little bit softer and I wanted a tight fit on the lid. I haven't tested with PLA, so I'm not sure how easy it is to snap on. If it's too tight, feel free to remix or let me know and I can modify it a bit.
 

Tagi