1 / 1
Heater Recirc mod waste chute guide for Shay's Poop Chute — zdjęcie 1

Heater Recirc mod waste chute guide for Shay's Poop Chute

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Chute guide for Shays left hand chute compatible with K2 Plus heater recirc mod

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
77
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A custom chute guide for Shay's great Poop Chute design (left hand version only)

I run the magnet version of Zemlins awesome Heater Recirculation mod (For recirc'ing chamber heat from the exhaust back into the heater intake for faster chamber heating with ABS/ASA/etc)

This does interfere with the waste port and i found it impossible to find a poop chute that'd work with it

I really liked Shay's design for the chute and bucket so i created my own guide that'd guide waste into the chute with or without the recirculation mode in place. 

This guide also has the added benefit of giving you a spot to "push" the recirculation mode piece into for when you're blinding reaching around the printer and sliding it into place (just don't push it in tight, pull it back and down slightly to make sure you're actually covering your holes)

Just adjust it so the top of the chute lays flat on the bed and the piece prints up into the air. Everything is angled so it will print without supports on the K2 Plus without issue.

Tagi