1 / 8
Minimalistic coffee filter holder with clamping function.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This minimalistic holder fixes the coffee filters neatly to the side using a clamping function.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 42
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a holder that could fix the coffee filters to the side, regardless of the number of filters left.
It should also require only a small amount of filament.
This is achieved by clamping them to one side using the spring force of the s-shaped arm.
Only 20 grams of filament needed.
Printing:
- Nozzle: 0.4 mm
- Layer height: 0.2 mm
- Supports: none (built-in)
- Filament: PETG
Assembly:
- Remove the built-in support using a flat headed screwdriver.
- If necessary, also remove any filament drops and strings.
- Place the clamp arm in the slot by twisting the flat body using a little force and insert it into the slot (see pictures).
- Press the flat body into the front side and make sure that the body is flush both at the front and rear side of the slot.
Mount;
- Place the filter holder flat on a surface or fix it to the side of the cabinet using screws or double sided tape.
Note:
- The model was intended to be placed to the left of the cabinet. If you prefer the opposite, you can just mirror the model in the slicer.