Zuru XShot Piston Pump - Lasgun
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Following on from the Bolter remix, now for a Lasgun!
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 628
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Another mashup of community models, this time to resemble a Warhammer 40K Lasgun. Inspriation taken from the Kantrael Pattern, but all actual design derived from the above sources.
The BCAR Shroud goes over the BCAR, and is held in place by putting a 210 O-Ring around the rim of the BCAR, so it friction fits. Previous version was a fully printed SCAR barrel, but that ended up being too flimsy. Cut the barrel down to 12.3cm if you want the blaster to be 130fps.
The shroud is an extended version of the original to give that boxy Lasgun look. The bracket has been modified to hug up to the magwell. The rails connect the shroud to the bracket and use 4x M3 10mm bolts.
I've linked to the stock I've used in my origins, but I've not made any changes, nor am I reposting the files here; go to the original page if you want to use them!
As with the Bolter, I've crudely mashed this up with Tinkercad, apologies for any mess!