TIG Filler Rod storage tube holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I just knocked myself up a quick basic trolley for my R-Tech Welding TIG welder to free up some bench space, and…
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 172
- Wydruki
- 1
- Wyświetlenia
- 1733
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I just knocked myself up a quick basic trolley for my R-Tech Welding TIG welder to free up some bench space, and wanted to store all the filler rods a bit nicer than just lobbing the tubes in a corner.
The filaments come in a 32mm diameter, 1m long see-through tube, with rubber end-caps on each end. There's two sections to this - one is designed as a base, for use without an end cap, the other is designed as a through support.
So, many hours in SketchUp, and about 4 hours printing per section on my Sidewinder X1, and I've got storage for 12 different filler rods - 3 sizes each of 316L Stainless, Mild Steel, and 5356/4043A aluminium.
Secured with M5 dome-head bolts.
I sliced it in Cura 4.10, and used Tree supports for the bolt opening.
Category: DIY