Snowsky Retro Nano Case (For use with Bigger battery)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snowsky Retro Nano case with slot for external battery.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 490
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my first real creation with modeling so there can be some issues and is not perfect but it works for me.
It has been a while since i printed and put it together but if i remember correct the parts i used were the following.
A Single 3.7v 1500 mah Battery with the dimensions: 50 x 35 x 8mm.
4 Threaded Inserts with the dimensions: M2.5x4x3.5
4 M2.5x4 Countersunk mechanical screw.
Keep in mind you only need 1 Main body printed, and use a filament that is suited for higher temps than PLA.
also its a bit of a tight squeeze with the audio jack since it has a bit of an edge but it fits for me with a bit of fiddling.