1 / 3
Creative stage SE monitor stand mount — zdjęcie 1
1 / 3

Creative stage SE monitor stand mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Creative stage SE holder that can be mounted to a tube of monitor stand.

Ocena
0 / 5
Polubienia
3
Pobrania
13
Wydruki
0
Wyświetlenia
177
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Creative stage SE holder that can be mounted to tube of monitor stand.
Typical rubber feets (Ø8mm, 2.2mm height) can be installed to the base plate to hold soundbar in place and avoid any possible rattling.
Clamp uses M5 nut and approx. 10-14mm hex screw with cylindrical head.
3mm screw in the tube clamp can be used to tilt the soundbar, head of the screw should make contact with rubber feet on the back of the back plate to avoid rattling.
Clamp is designed for monitor mount with 35mm tube, but model can be easily modified, FreeCAD file is attached.

Print settings

Layer height: 0.20mm
Supports: not needed
Material: PETG
Seam position: seam shouldn't be in contact points of the joint between tube clamp and base plate.
Orientation: tube clamp should be printed with bottom on the print bed, Base plate should be printed on its side.
Brim: I managed to print the base plate without brim, but I would recommend enabling it, because there is high chance the printed model will warp and loose contact with print bed.

Recommended seam position

 

Tagi