1 / 3
Creative stage SE monitor stand mount — image 1
1 / 3

Creative stage SE monitor stand mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Creative stage SE holder that can be mounted to a tube of monitor stand.

Rating
0 / 5
Likes
3
Downloads
13
Makes
0
Views
177
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Creative stage SE holder that can be mounted to tube of monitor stand.
Typical rubber feets (Ø8mm, 2.2mm height) can be installed to the base plate to hold soundbar in place and avoid any possible rattling.
Clamp uses M5 nut and approx. 10-14mm hex screw with cylindrical head.
3mm screw in the tube clamp can be used to tilt the soundbar, head of the screw should make contact with rubber feet on the back of the back plate to avoid rattling.
Clamp is designed for monitor mount with 35mm tube, but model can be easily modified, FreeCAD file is attached.

Print settings

Layer height: 0.20mm
Supports: not needed
Material: PETG
Seam position: seam shouldn't be in contact points of the joint between tube clamp and base plate.
Orientation: tube clamp should be printed with bottom on the print bed, Base plate should be printed on its side.
Brim: I managed to print the base plate without brim, but I would recommend enabling it, because there is high chance the printed model will warp and loose contact with print bed.

Recommended seam position

 

Tags