1 / 12
Sovol SV06 Anti-Wobble Z-axis Lead Nut Holder (Low-Profile) — zdjęcie 1
1 / 12

Sovol SV06 Anti-Wobble Z-axis Lead Nut Holder (Low-Profile)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Low-profile Z-axis lead nut holder using reversed thrust bearings to reduce wobble and improve print quality.

Ocena
0 / 5
Polubienia
10
Pobrania
31
Wydruki
0
Wyświetlenia
324
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Low-profile anti-wobble lead nut holder designed specifically for the Sovol SV06 Z-axis. This design repurposes a thrust bearing as a flat sliding ball bearing, allowing the lead nut to move smoothly in-plane with very low friction, low starting force, and no catching or binding. This reduces Z wobble transfer to the print, resulting in smoother prints and fewer Z-artifacts.

Why low-profile matters:

On the SV06, the Z motor and lead screw are connected via a coupler, leaving almost no clearance between the coupler and the stock lead nut, which sits underneath the XZ carriage. Because of this, other anti-wobble designs typically relocate the lead nut to the top of the XZ carriage, or replace the Z motor with a lead-shaft-integrated one to make room there. This holder is designed to stay within roughly 13.5 mm thick, and this avoids both of those modifications, keeping the lead nut in its original position underneath the carriage with the stock Z motor.

Track record:

This holder is based on my previous universal Simple High-Performance Anti-Z-Wobble Lead Nut, redesigned as a thinner, low-profile version specifically for the SV06. The original design has been used long-term by several makers who continue to rely on it, and this SV06 version has been long-term tested as well, delivering the same results — smoother walls and fewer visible Z-artifacts.

I run XY acceleration tuned via Input Shaper up to the practical limit for print quality, and use Z-hop regularly. Print quality has remained consistently excellent under these conditions, with no bouncing or jumping.


Bill of Materials (BOM):

New parts:
  • F12-21M thrust bearing × 2

  • M3×8 screw (cap head or button head) × 2

Reused from Sovol SV06:
  • Lead nut × 2

  • M3×5 screw × 4

  • M3×8 screw × 4

Printing notes:

  • Material: PETG, ABS, or other high-temp filament for heat resistance

  • Orientation: print flat, no supports needed

  • Print settings: a Voron-style profile is recommended

Assembly:

See the figure below.

Notes:
  • Reverse both ball races of the F12-21M thrust bearing so they function as a flat sliding ball bearing, as shown in the figure above.

  • The new M3×8 screw acts as an anti-rotation stopper. Do not fully tighten it — leave a small gap (≈ 0.5 mm) so the flat races can still slide against each other. All other screws (reused) should be tightened normally.

Tagi