V2.4 Alternate Z motors 4:1 Lever tensioned
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
with proper tensioner
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 144
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
its 4:1 now. if you want to use the same 5:1 (16t pulley) you either need to adjust the motor position a bit, or order a shorter belt.
Assembly is really bad (it can be assembled, its just… very unintuitive)
screws in first, assemble everything loosely, screw to the frame, then tighten evering down, and then last step, insert the lever and pin for it.
Requires cursed hardware!
i wont take the time to list all hardware but a couple outliers that are not common are:
Screws:
- 8 | M5 x 45mm
- 4 | M3 x 40mm
- 8 | M3 x 50mm
Pins
- 4 | M5 x 14mm
- 4 | M5 x 30mm
Extras
- An extra 625 bearing
- 5-10mm Spring
- 20T pulley 5mm ID
- 4 | 6x3x10mm Blue Spring
The idlers are supposed to be spring tensioned. you can also just not use any springs, and use 45mm screws instead of the 50mm ones.
Rest is stock voron Z drive, with the addition of a bearing for double shear for the motor.
and some semi oddball lengths M3 screws.
If you do decide to build this, mirror every part you print.
Ie, print 2x all the parts, and 2x all the parts mirrored.
This may seem obvious but dont forget to mirror the idler aswell (its asymmetric)
The holes which require the 5mm pins will need to be cleared out with a drill after printing to get a good fit.