1 / 6
V2.4 Alternate Z motors 4:1 Lever tensioned — image 1
1 / 6

V2.4 Alternate Z motors 4:1 Lever tensioned

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

with proper tensioner

Rating
0 / 5
Likes
3
Downloads
6
Makes
0
Views
145
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

its 4:1 now. if you want to use the same 5:1 (16t pulley) you either need to adjust the motor position a bit, or order a shorter belt.

Assembly is really bad (it can be assembled, its just… very unintuitive)

screws in first, assemble everything loosely, screw to the frame, then tighten evering down, and then last step, insert the lever and pin for it.


Requires cursed hardware!
i wont take the time to list all hardware but a couple outliers that are not common are:
 

Screws:
  • 8 | M5 x 45mm
  • 4 | M3 x 40mm
  • 8 | M3 x 50mm
Pins
  • 4 | M5 x 14mm
  • 4 | M5 x 30mm

Extras

The idlers are supposed to be spring tensioned. you can also just not use any springs, and use 45mm screws instead of the 50mm ones. 

Rest is stock voron Z drive, with the addition of a bearing for double shear for the motor.
and some semi oddball lengths M3 screws.

If you do decide to build this, mirror every part you print.

Ie, print 2x all the parts, and 2x all the parts mirrored.
This may seem obvious but dont forget to mirror the idler aswell (its asymmetric)

The holes which require the 5mm pins will need to be cleared out with a drill after printing to get a good fit.

Tags