Case for Multimeter needle probes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for Multimeter needle probes
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this case for these multimeter needle probes:
ANENG PT2003 Pen Extension Needle Tip 1 Pair Probe Tip Test Fine tip 1000V/10A Bendable Probe Detachable Accessories Tester Tool - AliExpress 1420
May work with others, step file is included in case your needle probe adapters are different. Probes will push in and be contained by 4 lever arms so they won't fall out. Simple pull to remove from the case, the small indent in the probes themselves will allow the lever to flex enough to remove.
Printed in PETG. I wouldn't recommend PLA due to concerns over fatigue in the levers. When slicing, you may need to adjust the setting “Minimum Feature size” in Orca slicer to prevent slicer defects in the lever arms. I had to lower this from the default 25% to 20%. You can see the defect in the attached slicer screen shots (one showing a bad slice, the other good).