FreeTrack Cap Point Model
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This is a cap style point model for use with OpenTrack, FreeTrack, or FaceTrackNoIR. It is designed for external power, either via USB or a battery pack. Check out the Serial Build guide on the FreeTrack forums here: http://forum.free-track.net/index.php?showtopic=1856
PointModel dimensions are 80mm side to side (40mm from centerline), 60mm up, 90mm back.
Design is based around 0.3mm layers for speed, but any layer height <=0.6mm should work fine.
Print flat, trim and assemble as needed. Put some hot glue in the corners to stiffen it up and lock everything down, then wire up.
I used some heatshrink around the LEDs to hold them in place after wiring, but hot glue would work fine - they're a pretty tight fit by hand to begin with, so they don't take much to stay stuck.
Category: Video Games