FreeTrack Cap Point Model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a cap style point model for use with OpenTrack, FreeTrack, or FaceTrackNoIR. It is designed for external…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 18
- Makes
- 0
- Views
- 335
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
This is a cap style point model for use with OpenTrack, FreeTrack, or FaceTrackNoIR. It is designed for external power, either via USB or a battery pack. Check out the Serial Build guide on the FreeTrack forums here: http://forum.free-track.net/index.php?showtopic=1856
PointModel dimensions are 80mm side to side (40mm from centerline), 60mm up, 90mm back.
Design is based around 0.3mm layers for speed, but any layer height <=0.6mm should work fine.
Print flat, trim and assemble as needed. Put some hot glue in the corners to stiffen it up and lock everything down, then wire up.
I used some heatshrink around the LEDs to hold them in place after wiring, but hot glue would work fine - they're a pretty tight fit by hand to begin with, so they don't take much to stay stuck.
Category: Video Games