1 / 3
Pulsar Xlite V2 Dongle Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A convenient place to store the dongle if you move around a lot with your mouse.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 1
- Wyświetlenia
- 146
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I use a Pulsar Xlite v2 Mini as an on the go mouse and was annoyed there wasn't a convenient place to put the dongle when not in use. So, I made a holder for the dongle. I imagine you could use this for other devices as well.
Placement is a little finicky so I recommend using a small dab of hot glue so that you can try again easily. If placed right, the holder and dongle should not stick out at all.
Print Settings:
- Orientation - Model is preset to the right orientation
- Layer Height - 0.2mm is fine
- Material - PLA+ works great, have used PETG as well
- Infill - Shouldn't need to worry about this as the model is all vertical walls
- Support - Not necessary
- Rafts - If you don't have good bed adhesion you may want to consider a raft