1 / 3
Pulsar Xlite V2 Dongle Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A convenient place to store the dongle if you move around a lot with your mouse.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 15
- Makes
- 1
- Views
- 146
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
I use a Pulsar Xlite v2 Mini as an on the go mouse and was annoyed there wasn't a convenient place to put the dongle when not in use. So, I made a holder for the dongle. I imagine you could use this for other devices as well.
Placement is a little finicky so I recommend using a small dab of hot glue so that you can try again easily. If placed right, the holder and dongle should not stick out at all.
Print Settings:
- Orientation - Model is preset to the right orientation
- Layer Height - 0.2mm is fine
- Material - PLA+ works great, have used PETG as well
- Infill - Shouldn't need to worry about this as the model is all vertical walls
- Support - Not necessary
- Rafts - If you don't have good bed adhesion you may want to consider a raft