1 / 3
TS21/C210 tips holder for IKEA Skadis (T-Clip System) — zdjęcie 1
1 / 3

TS21/C210 tips holder for IKEA Skadis (T-Clip System)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tips holder for IKEA Skadis, allowing putting multiple side by side as your collection of tips expands

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
103
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

A Miniware TS21 / C210 soldering iron tip holder for IKEA Skadis.

It uses the T-Clip locating pin variant, so it shouldn't rotate. Should be used with low profile clips.

I printed in 0.20mm PETG, others should work too. Print upright with no supports.

To install it, first put the T-clip through the clip seat on the model, then put the other side of the T-clip through the hole on your Skadis. Finally, align the part and tighten the T-Clip.

Tagi