1 / 3
TS21/C210 tips holder for IKEA Skadis (T-Clip System)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tips holder for IKEA Skadis, allowing putting multiple side by side as your collection of tips expands
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 18
- Makes
- 0
- Views
- 103
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
A Miniware TS21 / C210 soldering iron tip holder for IKEA Skadis.
It uses the T-Clip locating pin variant, so it shouldn't rotate. Should be used with low profile clips.
I printed in 0.20mm PETG, others should work too. Print upright with no supports.
To install it, first put the T-clip through the clip seat on the model, then put the other side of the T-clip through the hole on your Skadis. Finally, align the part and tighten the T-Clip.