MR52ZZ bearing storage tube (chonky)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tube to store MR52ZZ bearings (those tiny bearings in the K1C extruder)
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
About
Storage tube for 16 MR52ZZ bearings (5mm outer diameter, 2mm inner diameter, 2.5mm height), the tiny bearing in the K1C extruder. It's a bit of a chonker, should help to actually find them back.
Print instructions
2 walls and 15% infill should do, PLA will do fine. I have not tested other materials, printed with eSun PLA+ myself.
Random seem position could improve the result if aligned is leaving too much gap.
Requires one of holder and one of tube STL to be printed.
Instructions
Load bearings by racking them onto the holder pin, that'll prevent them from going sideways when loaded. Once loaded the bearings should behave and stay on place nicely. There's also plenty of tolerance so it is unlikely any will get stuck.
When closing, depending on how the holder and tube are threaded you may have a bit more friction and an audible click that should keep the parts somewhat locked together.
OpenSCAD
OpenSCAD file requires the BOSL2 library, refer to the OpenSCAD docs on library setup.
I'll probably adapt this in the future to accommodate more bearing sizes.