Single-Stud Mount for EGO 320W Charger (CH3200)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount bracket for the EGO Power 320W charger (model CH3200) which allows the charger to be mounted on a single stud.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 195
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Share Alike
Mount bracket for the EGO Power 320W battery charger (model CH3200) which allows the charger to be mounted on a single stud instead of requiring something at least 4" wide. I tried to make this a quick print while still making it sturdy, but I suggest taking some care when placing batteries on the charger to reduce the amount of force on the bracket.
Print using PETG or another similar strong yet slighty-flexible material. PLA is likely not a good choice as some flex is needed for this model.
Use #10 screws (I used pan-head Robertsons) to attach this to the stud. Be careful to make them snug but do not over-tighten which may break the bracket!
There will be some resistance when putting the charger on as there isn't much clearance for the screw heads, however once fully seated the heads fit into the inset on the back of the charger so the charger will sit flat against the wall.
Print Settings
30% gyroid infill, 4 wall loops. I suggest making the pegs (starting at height 3mm) 100% infill, or at least more than 30%, to help them withstand the forces from placing batteries on the charger.
Files
- EGO Charger Mount V2EGO Charger Mount V2 - The main model file which can be imported into your preferred slicer
- EGO Charger Mount ORCA - Project file exported from Orca Slicer which includes the suggested infill settings and layer range modifier